What else are they called?...udders, codes
Yes Junkman...the wiper blades work fine...high, low, intermittent.
The problem is the device or mechanism that sprays fluid on the windshield to clean the windshield. It is not working. I have always heard and called them "windshield washers" so sorry if that terminology is causing confusion.
I did follow the links and read the posts. They were your usual high quality.
I have found and cleaned the udders...they had loose leaves and some crud but were dry and cleaned that out. I have since flushed them and all 3 seem open.
CODES: I may have misread a couple after looking at the data base but was working alone with my 53 year old eyes and writing as fast as I could!!!
10 PCM NO CODES
28 TCS NO CODES
40 BCM NO CODES
58 SDM NO CODES
60 IPC B0521H, B1160H
80 RADIO NO CODES
99 HVAC NO CODES
AOLDCM B2282H, B2284H, V1064H (U?)
A1RCDM B2263H, B2283H, B2285H, B2263H, V1064H
A6SCM NO CODES
B0 RFA NO CODES
At the very beginning, I did the obvious or usual stuff:
1) Checked fuse...OK
2) Checked fluiid level...OK
3) Pulled out the level sensor...it moves...appears OK
4) Disconnected the tube at the entry point to the windshield area. Then turned on washer (to check for plugged end points)...no fluid comes out when washer turned on.
I don't hear any motor or pump running when I turn on the washer.
Sorry for taking a couple of weeks to get back to the forum but life is a demanding game...if you play hard!