Corvette Forum : DigitalCorvettes.com Corvette Forums - View Single Post - Printed Circuit Board Repair
View Single Post
Old 11-07-2007, 07:26 PM   #4
Dirtbuster1
DC Crew
 
Posts: 388
Member #63009
Member since: Jul 2007
Location: Ga.

My Corvette(s)
1982 CE

Thanks: 0
Thanked 0 Times in 0 Posts
If it was a hard plastic type PCB I would not worry about the repair, but the see through plastic type does. I guess I could jumper a wire, but the space is less than 1/8 of an inch. I thought maybe just melting some solder between them. I might get a cold solder joint?

Dirtbuster1 is offline   Reply w/quote