Corvette Forum : DigitalCorvettes.com Corvette Forums - View Single Post - Printed Circuit Board Repair
View Single Post
Old 11-07-2007, 07:28 PM   #5
big2bird
DC Crew
 
big2bird's Avatar
 
Posts: 5,916
Member #58543
Member since: Mar 2007
Location: Anaheim,Ca.,USA

My Corvette(s)
1981 T-Top Caprice powered Disco Buggy

Thanks: 0
Thanked 1 Time in 1 Post
Quote:
Originally Posted by Dirtbuster1 View Post
If it was a hard plastic type PCB I would not worry about the repair, but the see through plastic type does. I guess I could jumper a wire, but the space is less than 1/8 of an inch. I thought maybe just melting some solder between them. I might get a cold solder joint?

I would use the jumper. To avoid a cold joint, use Eutectic solder.
big2bird is offline   Reply w/quote