Corvette Forum : DigitalCorvettes.com Corvette Forums - View Single Post - An Old Man's Guide to Painting a Corvette
View Single Post
Old 02-05-2019, 07:22 PM   #102
7TRoadster
DC Crew
 
7TRoadster's Avatar
 
Posts: 1,773
Member #106320
Member since: May 2010
Location: Kennewick, WA

My Corvette(s)
1970 Roadster, Mast Motorsports LS7, TKO 600, SS Frame, C4 suspension

Thanks: 44
Thanked 162 Times in 144 Posts
Feather edge over spray

Because this car is being sprayed with fine metallic base coat paint it is necessary to block with 600 grit paper. Wait a couple of days to let the clear over spray from the jams set up. Block the car wet with the short blocks directly over the 400 grit scratches, a drywall sponge works really well at keeping water flowing while you block. Keep the surface wet and don't press down very hard, a light blocking is all that is needed. Wet primer blocks off quickly so only a few passes over any given area is needed, follow good blocking techniques. Block the whole car, takes about 2 hours. Scuff the recessed edges of the marker lights with fine (gray) scotch cloth but not the deeper parts of the recesses. Also scuff the lower halves of the tail light recesses, the exposed fender vent edges, wheel well edges and front grill edges. Give the over spray on the body a little extra attention, they need to contour into the primer seamlessly. You should not have blocked down far enough to expose any black. Fine metallics will flow across 600 grit scratches without showing the scratches. When completed rinse the car thoroughly with clean water, the drywall sponge works great here too. Blow out the cracks and crevices with compressed air and let the car dry completely.
Attached Thumbnails
Click image for larger version

Name:	Blocked with 6oo.jpg
Views:	70
Size:	48.1 KB
ID:	23798  
7TRoadster is online now   Reply w/quote