|
Trailing Arm Bushing Clearance
What is the correct clearance and tolerance between the trailing arm (TR) bushing sleeve and bolt? I purchased both stainless steel (SS) and plain steel (PS) sleeves, but the inside diameters are 0.468 and 0.445 inch, respectively. The bolt outside diameter is 0.437 inch. I installed the SS sleeve in one TR because the PS sleeve cracked while flaring it. The clearances of the SS and PS sleeves are 0.031 and 0.008 inch, respectively. Can I use the SS sleeve TR with the greater clearance? It feels too loose compared to the PS one.
Last edited by Road Tripper; 07-12-2019 at 01:05 PM.
Reason: Spelling Mistake
|
