Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 20 of 22 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
I'm putting the 04 ZO6 stripes on my 2000 Convert. I have some good pictures but the guy doing the work needs some measurements. Car goes in Tuesday evening and comes out Friday evening. Can someone help me with measurements?

I need the widest point at the rear of hood (outside red to red). I need to know the width of the red accent stripe at it's widest point (at the front of hood). As for the rear I need to know the widest width at the rear window and at the end of trunk where the cross flags are.
I sure will be grateful for these measurments.
Thanks,
Gary
 

·
Premium Member
Joined
·
6,667 Posts
Sorry for the "half 16th's" but my buddy with the Z16 measured them with a tape measure.

Hope this helps, it's not the best, and definitely not from GM's diagram.
Good luck.:cheers:

 

·
Registered
Joined
·
3,964 Posts
corvettestripes.com should have the exact measurements for you.:thumbsup:
 

·
Registered
Joined
·
3,964 Posts
Dude is your smiley icon kicking me in the nuts? Cuz I will bring my smiley possey and Kick your butt.:laughing:

 

·
Registered
Joined
·
20 Posts
Discussion Starter · #9 ·
They turned out GREAT! Silver car, convertible with torch red interior. Back stripe with red trim stripe. Also had the DRM heat extractor hood. Don't know how to post pics but I can email to anyone that can.
Gary
 

·
Premium Member
Joined
·
6,667 Posts
Wow, they do look great, fantastic job!!:cheers:

I'll have them up in a few minutes.:thumbsup:
 
1 - 20 of 22 Posts
Top