Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2,409 Posts
Discussion Starter #1
This afternoon I installed a 1 inch TD Performance 4 hole spacer under my Edelbrock carb. Once again, I can't give before and after dyno numbers, but the spacer did indeed improve low end torque:thumbsup:

FYI, the piece quality was poor. I called TD to let them know about their shortcomings.
1- the "flat" surfaces were not nice. I filed flat the burrs and lumps.
2-The through holes for the carb studs were not on correct centers. I had to enlarge two holes kitty corner 0.070" to bolt up.

Other than that.....It's a keeper:cheers:
 

·
DC Pit Crew
Joined
·
11,957 Posts
good deal rudy....just a note to other C3 owners you need to have the highrise hood to use the spacers :D
 

·
Registered
Joined
·
2,409 Posts
Discussion Starter #6
Onyx Black said:
You should put this product in the review section here.:cheers:
Done:cheers:
 
1 - 7 of 7 Posts
Top