Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Is there a trick to getting this thing in? The Service manual tells how to align and torquing the bolts, but there doesn't seem to be enough room to get it in.
 

·
Registered
Joined
·
1,855 Posts
Angle engine down ( watch dist to firewall clearance ) as far as possible to drop end of trans
Slide beam on to diff pushing it as far back as possible ( will be past and alongside the diff mounting pad ).
Lever trans to side and push beam up alongside trans.
Jack up trans to level and push beam up with it until beam will slide forward and on to the trans pad
 
1 - 5 of 5 Posts
Top