Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
185 Posts
Discussion Starter · #1 ·
it seems to be coming out at resevoir nipples and overflow nipple. they are quite loose in their mounting locations. can i just use some solder on these? will it hold with the heat and pressure? anyoneelse dealt with this. the hoses are tight on the fittings its the fittings are actually loose like the welds have broken. any little bit of help is great, and those who've had this issue PLEASE chime in.

:thumbsup:

finally running again and this is just a minor issue. though with hood open if i goose the throttle you should see the upper radiator hose collapse: looks like the vacuum being applied to it is VERY strong.
 

· Registered
Joined
·
3,517 Posts
I'm assumming you tightend up all the hose clamps

If there is a leak pull the tank and replace it with a new one

Bon
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top