Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,523 Posts
Discussion Starter #1
This morning I the went to my friends shop and started working on my drivers side T/A in hopes that the stubborn pivot bolt would be air hammered out but within 30 seconds of that I gave up and started sawzalling the bolt with Diablo and Lennox blades and with just two blades (one per side of the bolt) which wasn't absolutely necessary and 10-15 minutes of time I had sawed through both ends. I'll have pics later tonight.
 

·
Registered
Joined
·
2,948 Posts
This morning I the went to my friends shop and started working on my drivers side T/A in hopes that the stubborn pivot bolt would be air hammered out but within 30 seconds of that I gave up and started sawzalling the bolt with Diablo and Lennox blades and with just two blades (one per side of the bolt) which wasn't absolutely necessary and 10-15 minutes of time I had sawed through both ends. I'll have pics later tonight.

Hopefully a cold beer too. Good work.
 
1 - 3 of 3 Posts
Top