Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,187 Posts
Discussion Starter #1
Hey all you Austinites (and surrounding areas)! It's getting close to that time where I'm going to start modding (finally). Where have you fine folks been taking your Vettes? I found one place in Buda (ART I believe). Does anyone have any experience with them, or any other suggestions?
Thanks in advance.
 

·
Registered
Joined
·
948 Posts
Aww, hands down it's...

http://performance-motorsports.com/

Chris Johnson is very good...He works on S.P.'s cars, if that gives you an idea of his abilities. It's right off of MoPac...I highly recommend you pay them a visit!
 

·
Registered
Joined
·
546 Posts
HPE (horsepower engineering) is in Houston. They do everything there from exhaust to heads/cam or supercharging

www.horsepowerengineering.com

6915 Breen
Houston, Texas 77086
281-448-1300
 

·
Registered
Joined
·
1,187 Posts
Discussion Starter #4
Thanks guys! Love this forum and the people on it! I'll check into these! Thanks again!:thumbsup:
 

·
Registered
Joined
·
546 Posts
no prob. what mods were you looking at doing?
 

·
Registered
Joined
·
948 Posts
HPE (horsepower engineering) is in Houston. They do everything there from exhaust to heads/cam or supercharging

www.horsepowerengineering.com

6915 Breen
Houston, Texas 77086
281-448-1300
I'm pretty sure you requested a good shop in Austin in which case Performance Motorsports would not disappoint you. However if you are planning on making a trip to Houston you might as well go to MTI:drink:
 
1 - 6 of 6 Posts
Top