Joined
·
35 Posts
what are the ways to adjust the release point or engagement of the clutch on a 69 vette. On my car
the release point is about an inch or less from the
floorboard. Can you adjust the ball stud that works
with the clutch fork with the transmissson still in the
car by going thru the clutch fork slot in the bell housing.
Also is the length of the throw-out bearing a factor in it?
Thanks
the release point is about an inch or less from the
floorboard. Can you adjust the ball stud that works
with the clutch fork with the transmissson still in the
car by going thru the clutch fork slot in the bell housing.
Also is the length of the throw-out bearing a factor in it?
Thanks
