Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
341 Posts
Discussion Starter #1
i have a chance to buy two dana 44s ,one 3.01 and the other 4.88. the later is fully reconed.the price is AU $950.
will it fit into my car which has a D36 ? not sure if the batwings are the same:thumbsup:
 

·
Registered
Joined
·
13 Posts
You need the
-Third member
-Batwing
-C beam
-Drive shaft

The rest is the same between the 36/44
 

·
Registered
Joined
·
1,855 Posts
i have a chance to buy two dana 44s ,one 3.01 and the other 4.88. the later is fully reconed.the price is AU $950.
The 4.88 head has been for sale for ages at the same price .
Asking price is realistic compared with USA but he is unlikely to sell it in Oz .Is really a " strip only" ratio for a all out race car

I doubt you will find a D44 batwing to match it in Oz; finding a complete D44 is hard enough.

Bat wings run $650+ in the USA

http://cgi.ebay.com/ebaymotors/Corvette-C4-Carrier-DANA-44-Rear-Batwing-_W0QQcmdZViewItemQQhashZitem19c0907448QQitemZ110604874824QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

Is the 3.01 D44 ( 3.07 actually ) complete with batwing or only a diffhead also.
Price ?
 

·
Premium Member
Joined
·
341 Posts
Discussion Starter #4
the price is for both and i am not sure but i think it just the diffs for sale. thanks anyway guys i will stick with my 3.73
 
1 - 4 of 4 Posts
Top