Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
130 Posts
I had the same problem with percolation with a Speed Demon on an Edlebrock RPM manifold. A one inch phenolic spacer uder the carb along with dropping the float level to the point where you can just start to see it at the bottom of the sight glass was the fix.
I run 1/4 inch composite gasket/spacers under both Demons on a 6/71 blower and still no perc. problems.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top