Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
This is probbaly a dumb question, but I didn't take a whole lot of time messing with it...I was quick trying to take off my door panel to see why they weren't hanging correctly, but when i went to get the screw behind the lock slider, i couldn't figure out how to get to it. DO you take the slider off? How?

I think i figured out how to get them to hang right, but i need to get them off to work correctly. Any help would be great.
 

·
Registered
Joined
·
541 Posts
Ok well there is like 5 screws at the bottom, 1 and 1 on each end, two in the handle and three where the door lever is. One is behind the light, one in the center(visible), and the one behind the door lock lever. You need to pop it off with a little flat blate or you might be able to pull it off by pulling on it. But one screw is back there... Good Luck

Frank
 
1 - 2 of 2 Posts
Top