one guy on cf uses the nitto cucachirra knife maker but he ran preety good with them. ask him. i dont think i spelled his name right but close enough its in the 1/4 mile bolt on list
Drag Racing with Nittos
I'm going to try a set of Nitto 555R...305-18 drag radials on stock ZO6 front rims....18x9.5" I have zo6 fenders so it should fit fine. Anyone tried this combination on the back?? I am only going to use this combo at the drag strip. Any comments on the nitto's. I was told to run 20psi in them at the track. Do you think I will need sensors in the rims if they will only be on the car for a few hours?
Thanks in advance for any good advice.
Thanks in advance for any good advice.
1 - 2 of 9 Posts
i went 1.7's 60 ft. on the stock runflats in the 11's with bfg dr 1.588 60 ft in the 11.s a4 bolt on's i would go with the bfg dr. dont think the nittos will work
1 - 2 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Corvette Forum : DigitalCorvettes.com Corvette Forums
A forum community dedicated to Corvette C Series owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
