Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
84 Posts
Discussion Starter #1
I just finished the fabrication and instalation of the loop required for dragracing, (required if you meet certain criteria, maybe slicks, maybe times, not sure, but it looked like a good thing to do as long as I was in this far).

The kit was made by Lakewood Industries and cost me around $44. I used less than half of the materials supplied in the kit, do to the fabrication. There is everything you need to do another one left over accept 3 or 4 lockwashers. [email protected]
 
1 - 1 of 1 Posts
Top