Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,079 Posts
Discussion Starter · #1 ·
Can the lower control arm shaft be installed upside down?

On the passenger side I have the front 2 bolts torqued and I have about a 1/16 gap between the shaft at the bolt holes and the crossmember mount. There isn't a gap on the rear bolt. I torqued it with the spring fully compressed in the compressor tool, so there isn't any spring resistance.

I didn't notice if it was this way before I replaced the bushings.

Guess I'll have to loosen the shaft bolts and turn the shaft.
 

·
Registered
Joined
·
96 Posts
1 - 4 of 4 Posts
Top