Ebcm [how to remove?]
1 - 3 of 3 Posts
Joined
·
25,812 Posts
Replacing the BCM (Body Control Module is not difficult but there are a few cautions.
Don't touch the connector pins or soldered components on the circuit board or something might short out
Make sure the ignition is OFF when disconnecting or reconnecting power to BCM
Make sure you reinstall the connector the correct way. It shouldn't take much force to push it on.
Turn OFF the ignition switch.
Remove the front floor kick-up panel
Pull up on the BCMs lower mounting tab to release the BCM from the bracket.
Release the BCMs upper mounting tabs by lifting the BCM out of the slots in the bracket.
Disconnect the connectors.
Lift the BCM out
Don't touch the connector pins or soldered components on the circuit board or something might short out
Make sure the ignition is OFF when disconnecting or reconnecting power to BCM
Make sure you reinstall the connector the correct way. It shouldn't take much force to push it on.
Turn OFF the ignition switch.
Remove the front floor kick-up panel
Pull up on the BCMs lower mounting tab to release the BCM from the bracket.
Release the BCMs upper mounting tabs by lifting the BCM out of the slots in the bracket.
Disconnect the connectors.
Lift the BCM out
Joined
·
48 Posts
I think he is referring to the Electronic Brake Control Module. It is easy to pull out.. I forget the size of the torx screws, but there are 6 of them and two plugs that you have to unhook.
1 - 3 of 3 Posts
