Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 2 of 2 Posts

·
Super Moderator
Joined
·
10,071 Posts
Discussion Starter #1
I know I've harped on this before, but look right behind the front edge of the Frunk 'hood' in this pic. Sure looks like it has some deep indents (heat exhausts) about 12" wide and curving back about 12" on both sides of a center design piece that continues to the front from the rear edge of the 'hood.' This prototype is parked so it's likely that the cammo got stretched from the hot air (even if it is porous) while driving and at rest has sunken in a bit.



 
1 - 2 of 2 Posts
Top