Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 14 of 14 Posts

· Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
Just put on a Halltech Stinger. . . .replaced the stock air bridge. The car seems to really like the extra air. . . finds idle better, idles smoother, better throttle response, all in all a huge improvement. Very easy install, and a HUGE air filter!:thumbsup: Impressive. I'll dyno tomorrow and post the numbers!
 

· Premium Member
Joined
·
69,122 Posts
I love mine too! Install was a breeze. And for some reason that filter just stays clean all the time. I've driven the salt flats, thru snow, sand... and that filter still looks as good as new. Haven't touched it.
 

· Registered
Joined
·
66 Posts
Discussion Starter · #5 ·

· Registered
Joined
·
593 Posts
Just ordered my Halltech Stinger and Corsa Pace Car (Pro tips) system from Corvette Garage...can't wait to get them installed! They're my first drivetrain mods...
 

· Registered
Joined
·
3,827 Posts
Just ordered my Halltech Stinger and Corsa Pace Car (Pro tips) system from Corvette Garage...can't wait to get them installed! They're my first drivetrain mods...
Did you get the red or black Haltech?
 

· Registered
Joined
·
593 Posts
I've heard that too...but I can't believe it would receive such high praise if that's the case. I'll be installing mine in about 3 weeks...and will check the clearance. I won't keep it if it causes problems.
 

· Registered
Joined
·
764 Posts
I read somewhere that this intake makes your hood bow up because it does not fit cleanly underneath...Does it rub the underneath pad of your hood ?

When I had that setup, mine rubbed my headliner good enough to almost rub off the red halltech letters.

*** So what were the Dyno Numbers ***
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top