Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
New member, this is my first post. Site is fantastic, lots of good info and pictures. My problem is with my 1977 vette. I purchased the edelbrock rpm power package and got the angled plug heads. Motor is already in the car and I'm now having problems finding a set of headers to fit. I would have got the straight plug headers if I'd known it would be such a problem. Any ideas?
 

·
Registered
Joined
·
2,409 Posts
1st....welcome :buhbye: :thumbsup:

2nd...your best bet is to contact Edelbrock and some header makers for advice.

If it were me, I would make a 3/8" shim to move them out that much. The shim would also give you the opportunity to "D" port and control some reversion.:cheers:
 

·
Registered
Joined
·
35 Posts
I had the same problem with my angled plug heads. I ended up buying some Dynomax headers and they made enough room for plugs and wires.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
thanks for the info TShort. Would you know if your part # was 86008, those were the one's I was thinking of buying.
 
1 - 4 of 4 Posts
Top