Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
Hello,

Well just got my car on the road yesterday with its new 357 roller motor with AFR heads, serpentine belt set up, alum radiator and t-56 six speed installed! Car runs/drives awesome only problem my headers hang WAY too low. Every bump my headers or Pypes exhaust are dragging. I am willing to raise the car a little but not that much.

Any help with what headers tuck up nice and tight underneath would be greatly appreciated!
 

Attachments

·
Registered
Joined
·
2,948 Posts
What brand headers are you using now? Your signature lists them as Stainless.

I have always had great luck with Hookers. :thumbsup:
 

·
Registered
Joined
·
40 Posts
Discussion Starter #4
The old rusty full lenghts that were on the car when i bought it hardly ever hit!

Can't remember what brand they are bought them years ago and have been in storage. They are stainless and coated.
 

Attachments

·
Registered
Joined
·
19,476 Posts
Anything but Pypes. :thumbsup:

I could never understand why people buy Pypes systems after all the bitching about fitment on all the corvette sites. :huh:

I've got Hooker now, but my old long tube under car headers where Blackjack and had no clearance issues. :thumbsup:
 
1 - 5 of 5 Posts
Top