I think the owners manual has pretty good instructions. Basically (if I remember correctly), you have to remove the black plastic covers and adjust one of two torx screws (one for height, one for side/side).
Hey guys, thanks for the input so far, however, I have tried and seen all of the above.
It seems that only a 2.5 hex key is the only thing I have that will fit these adj. rods! Would there be a Torx Driver long enough to adjust these things or do I need a specific tool to do so?
Thanks for all input. I have these kick-ass HID's installed now that I can not use because it will blind the hell out of everyone even if you are 2 blocks away......they are way to high so I MUST adjust down to specs
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.