Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
872 Posts
Discussion Starter #1
Is there any measurement or point of reference data for the height of the doors and hood? Starting from scratch with the hood/door alignment but need height it should be at.
 

·
DC Crew
Joined
·
32,974 Posts
Let me go browse through my FSM and see if there is anything. Aside from that I would hang the door and get it level to the back of the car and hang the hood to match. Just a thought looking at it from the surface. Anyway I'll let you know if it has any good info in it.
 

·
Registered
Joined
·
872 Posts
Discussion Starter #3
Thanks i hope something shows as far as tolerances etc. Going nuts taking baby steps making it closer and closer to right.
 

·
DC Crew
Joined
·
32,974 Posts
I'm not able to find anything that gives specs on how it should be, just alot of how to on removal and replacement.
 

·
Registered
Joined
·
872 Posts
Discussion Starter #5
My 89 fsm is the same way R/I procedures but no specs. Whats the height of the hood latch pin from the base to the tip. There are two styles (rounded/pointed) but I have sets of each so that would make for a good starting point. :thumbsup:
 
1 - 5 of 5 Posts
Top