Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi All,

Just joined this forum and I have a question. My drivers door outside sealing strips (dew wipes) need to be replaced. I seem to remember that someone has written the procedure up and it is on one of the Corvette forums. Does anyone have any info on this strip replacement ?

Many Thanks,

Don in VT
 

·
Registered
Joined
·
724 Posts
I've done them on my 1985, and it wasn't that bad. You have to remove the door panels, and drill out the factory rivets. Then you can kind of bend it toward the outside and lift up at the same time and it should come right off. Clean the area and line the new ones up where the old was, push down until the they clip back in, and reinstall new rivets that should have come with the new seals.:thumbsup:
 
1 - 2 of 2 Posts
Top