Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 4 of 4 Posts

·
El Teafive
Joined
·
10,489 Posts
Discussion Starter · #1 ·
Does anybody know what size pop rivets I need for these?

the OEM Pass side was Red and the PO painted it black, I have a nicer set of used black handles I am going to swap. Just not sure on the rivet size
 

·
Registered
Joined
·
5,206 Posts
Don't freeze trying. :laughing: I could measure too, just figured someone might know.

I might even have some at work that are the right size
Sorry don't know the size either, but not too many sizes to choose from 3/16" or 1/4" my guess.

The important part though is to use the STEEL shafted rivet not the aluminum. The steel ones tighten up better and will not loosen up with use
 
1 - 4 of 4 Posts
Top