Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1 (Edited)
Jacking points on a C4 1994 convertible

I wanted to know if there is a website (or info) that shows where the jacking points are , I jacked up my vette and am confused looking under there , I heard you shouldn't jack it up on the leafs , but don't see anywhere to put my floor jack?
thanks for your help (post something!)
Eric:laughing:
 

·
Registered
Joined
·
46 Posts
Discussion Starter #2
Found them , on the 94 conv there is a metal X under the car the jacking points are each end of the X
 

·
Registered
Joined
·
4 Posts
On each side of the car, under the rocker panel on each end should be embossed arrows on the edge of the plastic. Be carefull of the floor pans and don't stick the jack pad too far underneath, just catch the lip only. Or....you can put the pad under the engine in the middle of the crossmember between the A-arms, and raise the rear from the chunk. Some vendor makes a 'jack-a-vette' tool that replaces the jack pad to get to the chunk between the exhaust pipes. (chunk = rear end)
 
1 - 3 of 3 Posts
Top