Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
Well Ive got a little prob fellas.... About a week ago I hop in and started her up then tried to reverse and she was a no go.... For some reason I cant get the car in any of the gears when shes on but can place her in 1st through 6th when off. Its like the gears close themselves shut when the motor is running..... I don't drive her often so she sat for like 2-3 weeks until I ran into this problem. She ran fine the last time i drove her. She did make a whining noise though when she was running but it quits when the clutch pedal was pressed. Maybe that's related to my current problem??
 

·
Registered
Joined
·
186 Posts
not sure if it applies

Could it be a 1-4 skip shift malfunction; not certain that existed yet for '91.
 

·
Registered
Joined
·
145 Posts
Sounds like the clutch is not fully disengaging. Does it grind when going into reverse?
 

·
Registered
Joined
·
42 Posts
Discussion Starter #4
I cant even get it into reverse at all or any gear for that matter.... Its like they close up.
 

·
Premium Member
Joined
·
17,444 Posts
Pretty obvious that the clutch is not disengaging.

Check master cylinder
Slave cylinder
operation of hydraulic system

If they are working go on to the throw out bearing, clutch and
pressure plate.
 
1 - 7 of 7 Posts
Top