Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hello,
Can I use the rear lower bolt stock to lower a "3/4 inch.
If so, owe I turn in the meaning of the hand of the watch (left-rihg) or the opposite.
 

·
Registered
Joined
·
1,078 Posts
Yes you can. Turn the wrench counter clock wise, which would be to the left. Back the bolt all the way out till it stops. The car should drop about an inch. Good luck.
 

·
Registered
Joined
·
33 Posts
Hello,
Can I use the rear lower bolt stock to lower a "3/4 inch.
If so, owe I turn in the meaning of the hand of the watch (left-rihg) or the opposite.
This was my 08 that I had turned all the way down and cut half of my rubber bushing. The fronts I just turned and did not cut the bushing.


The rears are going to be close to drop 3/4". On my 08 I had to cut half of my rubber bushing. In the front, I was able to turn the bolt to achieve my desired height. Let the car sit for a day or two, it will take it a couple of days for it to settle. You turn right to left (counter clockwise).
 
1 - 3 of 3 Posts
Top