Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
174 Posts
Discussion Starter #1
anyone know what the flange to flange is on our rear ends? i'm looking to go solid rear and it would be a great help.
 

·
DC PIT CREW BOSS
Joined
·
39,518 Posts
Don't know but here's a bump for you so one of the C3 guys might see it
 

·
Registered
Joined
·
174 Posts
Discussion Starter #4
with all the talk or rear suspensions and all that have there cars torn apart and konw one knows?
 

·
Registered
Joined
·
1,079 Posts
Must be dejavu...could have sworn I saw this question posted before...oh well, I must be goin nuts:smack

Bump for ya.
 

·
Registered
Joined
·
550 Posts
I never measured the "stock" one... If you do you''' want to make sure the halfshafts are parallel to the ground when you do....

I can measure all of the components but I dont have an assembled one. Axle width will be determined by what tire/rim combo you looking to do and how much flair.

Just curios why dump the IRS?... It's simple to fix and operates well in stock form...

:lookinup:
 

·
Registered
Joined
·
174 Posts
Discussion Starter #7
already broke it with less then stock motor, now i'm building a 500+hp unit and it might get sprayed. the cost to repair this one back to stock or the cost to upgrade i would rather use a 9 inch and not break it again. i'm a drag racer not a road racer.;)
 
1 - 7 of 7 Posts
Top