Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
982 Posts
Discussion Starter · #1 ·
Hey guys just put the nut on my right front spindle to tighten down the tire rod end. Its doubly sucked because I layed the car up for 6 months to do the oil pan gasket and up grade the springs and shocks too. Tightend it to much and actuly cracked the spindle. Any one have one laying around.
 

·
Registered
Joined
·
914 Posts
I don't understand what your talking about. Your car does not have a spindle nut. It has ball joints and the outer tie rod that connects the spindle to the car. The bearing hub assembly bolts onto the spindle and then the wheel bolts onto the bearing hub.:lookinup:
 

·
Banned
Joined
·
7,823 Posts

·
Premium Member
Joined
·
10,261 Posts

·
Banned
Joined
·
7,823 Posts
lighter, stronger, and allows for a 1" drop by itself.
 

·
Registered
Joined
·
3,516 Posts
Hey guys just put the nut on my right front spindle to tighten down the tire rod end. Its doubly sucked because I layed the car up for 6 months to do the oil pan gasket and up grade the springs and shocks too. Tightend it to much and actuly cracked the spindle. Any one have one laying around.
Tons of junk yard parts at the Baie
 

·
Banned
Joined
·
7,823 Posts
try a junk yard or corvetterecycling.com
 
1 - 8 of 8 Posts
Top