Noob checking in
1 - 7 of 7 Posts
Joined
·
53,209 Posts
Welcome noooo-b! Wow, we are really putting tacks in our "world map" on the wall.TwinTurbo said:
Besides a pluthora of Canadians & Americans, we have folks from Germany, Japan and Sweden also with us.... and now the Netherlands.
You simply have to tell us about the Corvette "scene" over there....
Patrick
Joined
·
1,873 Posts
The scne is pretty limited here, there are perhaps around 800 Corvettes or so, probably a lot less.
I used to be a founding member of a club but had some unpleasant experiences there, no need to get into details. I'm currently minding my own business, I have no interest in people leeching off me anymore.
... lone wrencher in a country where customizing and projects are really uncommon.
I used to be a founding member of a club but had some unpleasant experiences there, no need to get into details. I'm currently minding my own business, I have no interest in people leeching off me anymore.
... lone wrencher in a country where customizing and projects are really uncommon.
Joined
·
3,027 Posts
Welcome Marck!
Joined
·
53,209 Posts
Clubs suck. I don't blame you.TwinTurbo said:The scne is pretty limited here, there are perhaps around 800 Corvettes or so, probably a lot less.
I used to be a founding member of a club but had some unpleasant experiences there, no need to get into details. I'm currently minding my own business, I have no interest in people leeching off me anymore.
... lone wrencher in a country where customizing and projects are really uncommon.
1 - 7 of 7 Posts
Join the discussion
Recommended Reading
-
68 conv. total rebuild
C3 CorvetteI need help getting my 68 wiper system to work, I'm installing the new lectric limited dash harness into the car. After a 7 yr total rebuild I have gone with the LS1-TS6 conversion, and have got the headlight doors and wiper doors converted to electric, no more vacuum to rely on I followed wiper...- 0
- 289
-
Post a picture of your C3
C3 CorvetteHere is a picture of my '78 Vette just after I bought it in June 1985: This is what it looks like today:- 2K
- 768K
-
matchframe · updated
-
power steering control valve installation
C3 CorvetteI'm installing the ps control valve onto the drag link (not installed on the car yet). The valve is very hard to thread onto the rod. I put it in a vise and used a pointed bar to rotate it but I can only get it to within about 1/4 inch of all the way on. The bolt went in okay but I'm not sure if...- 2
- 297
-
Testing Fuel System Integrity
C3 CorvetteHey guys, what's the easiest way to check my LS3 fuel system for leaks (before I put the body back on) - setting up the system with in-tank pump (Tank's Inc GPA pump), the corvette LS filter/regulator, Holley Fuel rails with pressure gauge on the inlet to the rail. Without attaching any...- 3
- 215
-
77blue · updated
-
Pinion Bearing Preload Contradiction
C3 CorvetteMy 1978 manual states 20-25 in-lbs for new pinion bearings, but other sources state 14-19 and 15-17. Which is correct? It is intended to be a moderate performance street daily driver. Also, my current out of the car differential 10 bolt clockwise (from the front) is 16-19 in-lbs, but...- 2
- 450
Join now to ask and comment!