Problemo....taking my TPI oval intake up and over top of radiator....allready cut support, and hood is modded allready, have 3.5 inch induction setup allready....so....need a oval duct ~3" high, 4.5" wide, and down to about 3.5 inches round on front end...make it 18" long..... ~45* down angle....
what/where/how/how much....
aluminum tubing is out....not easily available...need tig welding anyway....
rubber hose....?? any other suggestions, except a junkyard raid....
cheeeeeeeper is better as always.....but it's gotta get DONE.....
what/where/how/how much....
aluminum tubing is out....not easily available...need tig welding anyway....
rubber hose....?? any other suggestions, except a junkyard raid....
cheeeeeeeper is better as always.....but it's gotta get DONE.....