Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
160 Posts
Discussion Starter #1
I need some help with the driverside pcv, can i put the hose from the valvecover to the back of the hsr plenum ???Or will that cause problems??
Im not allowed to use only breathers so i will fail the inspection if the hose isnt connected
 

·
Super Moderator
Joined
·
8,483 Posts
you can connect the vacuum line to the port on the back of the plenum or anyplace else on the plenum and it will work the ideal location would be on the under side like the air temp sensor is located but that will require having a threaded aluminum bung ring welded and a hole drilled



http://www.holley.com/986703ERL.asp
READ THIS
http://forum.grumpysperformance.com/viewtopic.php?f=55&t=1745&p=4381&hilit=stealthram#p4381

one more reason having a good TIG welder, and a drill press in the shops a huge help
 

·
DC Crew
Joined
·
32,974 Posts
Why not just cross it over and T it into the pass. side? You have that hooked up correctly, right?
 

·
Registered
Joined
·
1,855 Posts
ideal location would be on the under side like the air temp sensor is located
:thumbsup:

That is where I have my PCV line
IAT is relocated to one of the rear holes and it still works fine
 

·
Premium Member
Joined
·
341 Posts
I have mine on the underside of the plenum :thumbsup:- hole already there - air temp sensor relocated to front of air induction tube
 

·
Cleaner than Stock, Faster than Phock
Joined
·
726 Posts

·
Registered
Joined
·
547 Posts
I have mine on the underside of the plenum :thumbsup:- hole already there

air temp sensor relocated to front of air induction tube
Yes, there is already a hole for that purpose. The other hose will fit into your TB.

Why? Isn't there a hole at the back of the plenum?
 
1 - 7 of 7 Posts
Top