Pics
1 - 2 of 2 Posts
Joined
·
53,209 Posts
I was checking out those pics!!!g.red69 said:
This is one of the SWEETEST sharks I have ever seen!
--> http://www.digitalcorvettes.com/photopost/data/508/641DSC01092.jpg
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
power steering control valve installation
C3 CorvetteI'm installing the ps control valve onto the drag link (not installed on the car yet). The valve is very hard to thread onto the rod. I put it in a vise and used a pointed bar to rotate it but I can only get it to within about 1/4 inch of all the way on. The bolt went in okay but I'm not sure if...- 2
- 255
-
Testing Fuel System Integrity
C3 CorvetteHey guys, what's the easiest way to check my LS3 fuel system for leaks (before I put the body back on) - setting up the system with in-tank pump (Tank's Inc GPA pump), the corvette LS filter/regulator, Holley Fuel rails with pressure gauge on the inlet to the rail. Without attaching any...- 3
- 186
-
77blue · updated
-
Pinion Bearing Preload Contradiction
C3 CorvetteMy 1978 manual states 20-25 in-lbs for new pinion bearings, but other sources state 14-19 and 15-17. Which is correct? It is intended to be a moderate performance street daily driver. Also, my current out of the car differential 10 bolt clockwise (from the front) is 16-19 in-lbs, but...- 2
- 404
-
front rotor runout
C3 CorvetteTrying to dial in the front hub rotors. All new bearings, seals, and rotors. I put a dial gauge on the rotor and I am getting about .025 runout. I moved the rotor over one lug at a time and it didn't correct it. I tried the other rotor that I bought and it seems to be the same so I believe that...- 1
- 224
-
Post a picture of your C3
C3 CorvetteHere is a picture of my '78 Vette just after I bought it in June 1985: This is what it looks like today:- 2K
- 768K
-
matchframe · updated
Join now to ask and comment!