Corvette Forum : DigitalCorvettes.com Corvette Forums banner
Cancel

Qestion!!

1281 Views 8 Replies 4 Participants Last post by  kwplot34, 
kwplot34
I was installing an MSD 6A box, and was following the directions for wiring an MSD pro billet Dist,since that is what i will be using. Ok got it all wired and ran the original tach wire to the tach input on the 6A box. Read further on in the instructions and it mentioned a run on problem that might happen.
Has anybody experienced this probelm using the factory tach, and if so how do i fix it? and do i need to leave the capacitor in line that ran to the original dist?
Just thinking ahead in case i have a problem. Thanks in advance for your help.


Kevin
Reply
Save
Like
1 - 1 of 9 Posts
bojvette
To Run My Sun Tach I Had To Buy A Msd Tech Adapter Since I Have A Msd Blaster Coil !!! To Make It Work !!
As For The Stock Tach Since Its A Gear Drive I Did Not Have Any Problems With It !!
Reply
Save
Like
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Corvette Forum : DigitalCorvettes.com Corvette Forums
A forum community dedicated to Corvette C Series owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
C6 Corvette C3 Corvette C4 Corvette C5 Corvette - General Discussion General Corvette Discussions
Top