Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Do you need to take out the whole diff to replace the seal on the driver side diff yoke? How do you replace the seals on the ones on the side that are connected to the half shafts. I have a pic but it doesn't want to uploan "invaild file"?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
Picture

Thank you for helping me post that picture. I was told that this was an easy fix by my shop teacher and my husband is just tearing things off. Help is needed before replacing a seal becomes a rebuild. Thanks
 

·
Registered
Joined
·
230 Posts
It's an easy fix but it takes awhile to get there. Be sure to get a new diff gasket. It must be the 10 hole gasket for the 80-82 Corvette Dana. The 8 hole gasket will fit but it will warp the batwing.
Mike
 

·
Registered
Joined
·
5 Posts
Discussion Starter #6
Thank you

I am having no luck finding the gasket.. and both Napa and Auto Zone say it is a 13 hole or 12 hole. - I guess they think I can't count.. Going to have to order.. Thanks again...
 
1 - 6 of 6 Posts
Top