Corvette Forum : Corvette Forums banner

Rear End Crossmember Cushions?

2460 Views 8 Replies 3 Participants Last post by  JesterGrin_1
Would anyone know of the best place to purchase these? Mine have gone bye bye lol.

Thank You everyone in advance. :)

I was thinking that instead of replacing the Cross member Cushions I could just go ahead and mount it solid? But I have had a couple of people wade in to say that I should just replace the bushings so they would isolate the vibration.

I will be going with a mild Big Block of 550HP though. And since I am dismantling the whole rear end suspension I would rather do it right the first time and not have to go back for some time. :)
1 - 3 of 9 Posts
Just welded mine in solid. No test drive yet as the car is in pieces but keep in mind that this is mainly done on lowered cars to keep the halfshafts parallel.
Not dragging but road racing. Still am keeping the snubbers tho. I have a new locating kit Ill sell you if you dont have one yet.
Yeah the same I have. Just thought Id ask. Good luck getting everything back together!
1 - 3 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.