Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
281 Posts
Discussion Starter #1 (Edited)
Started today from bottom up. New Eagle crank going in
block tomorrow. Got cam tool from US today, also new
steering column part in eng. compartment. New Lunati Voodo cam goes in tomorrow. Then heads, gaskets etc. Based on
overall advice from numerous Brother C3'rs and other Vetters,
we have decide not to balance as we will not be going over 6000's.Once again thanks to B2B, TimAT, Matchdrame and all you other Guys who have generously donated time, friendship and genuine support. We'll keep you updated on progress. She may even run again.
 

·
Premium Member
Joined
·
17,444 Posts
Hey you know how us guys are up here the show me state...Gotta have pictures...word of the day is keep it clean.
 

·
Registered
Joined
·
281 Posts
Discussion Starter #3
Oh yeah

Hi Ivan, I'll try to get Mark to get a darn camera n take some........
Of course I know the "Show me State." I was a top DJ there on
KXOK St. LOuis in 65 at the time of the British invasion, hey
email me at [email protected] and I'll send you a big
spread about me i n the St' Louis Despatch, Mo.s biggest newspaper
buddy, then you can post it for me, I'm not good at that part.

("I'LL S H O W YOU")
 

·
Registered
Joined
·
3,100 Posts
Like IBurke said, keep it CLEAN. Surgically CLEAN. And if you have any questions about ANYTHING, post or call.

:cheers:
 

·
Registered
Joined
·
281 Posts
Discussion Starter #5
Hi Tim

Hey Tim.....where u been ?......haven't seen u fer a while,
Mark's gittin it 2gether....slowly but surely, We got the cam tool
and removed 1 cam 2day....didn't see any muck there. Things
will hopefully turnout ok........Mark's tryin hard to keep things clean.!
 
1 - 5 of 5 Posts
Top