Cool. Thanks for the pic. But inquiring minds have to ask. Whats the pipe sticking thru the floor pan? :huh:
1 - 6 of 6 Posts
Why its a drain pipe for the wet bar I'm installing in the passenger side dash :rolling: :rolling: :rolling: :rolling:
It is one of the 4130 chromemolly standoffs ( they poke up through the 'glass floorboards) with weld nuts that hold the seats... They end up being about 1.5 inches tall with about 3/4 inch protrucing through... It makes a quick solid mount. The combination x brace/seat bars and driveshaft safety loop is not yet installed in this pic.
Here is a pic in which you can see part of the driver seat mounting. Where the original seat belt mounting bracket was in the tunnel will be the new loop (out if 1/4 inch steel) and tie between each seat mounting subframe and the new inner seat belt mounts...
I was thinking.......... FART VENT
:rolling::surprised :surprisedI was thinking.......... FART VENT
The seats are so new nobody has farted in them yet :laughing: :laughing: :rolling: :rolling:
Well almost nobody
At least they were bare aluminum the covers are not on yet...:devil: :devil: :devil:
:surprised :surprised
The seats are so new nobody has farted in them yet :laughing: :laughing: :rolling: :rolling:
Well almost nobody
At least they were bare aluminum the covers are not on yet...:devil: :devil: :devil:
Ummm hummm....likely story...:devil: they were melted off....:smack
1 - 6 of 6 Posts
