Corvette Forum : Corvette Forums banner
1 - 3 of 3 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
Yes. I am doing the "Water pump / distributor" replacement. I have the water pump off and I have removed the three crankshaft balancer bolts.

But how do I remove the center bolt? The crankshaft in turning.

I also rented a balancer puller, but the claw tool was too small for my bolts. Should I be looking for certain tool?

Well for that matter! Can I remove the balance without pulling the whole engine out?

Thanks for the help
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.