[bossesjoe]

Does anyone know a good vendor for pre-fab eight or six point roll bars?

Thanks, Phil

 

[muddpile]

R-D Racing make one, but it looks like a 4 point job.

http://www.r-dracing.com/stframe1.htm

 

[Patrick]

Doug Rippie makes a 4 pt w/a diagonal, and you can just add to it and finish the cage.

What sucks is that there is almost NO room in a C4 for a cage where the bars aren't dangerously close to your head. Fine when you are wearing a helmet, bad for street driving as you risk serious head injury.

 

[Dan85Vette]

What sucks is that there is almost NO room in a C4 for a cage where the bars aren't dangerously close to your head. Fine when you are wearing a helmet, bad for street driving as you risk serious head injury.

Yea, the left side of the targa usually finds my head anyways.

I found it tough just wearing a helmet in the C4. Had to crank the seat straight to the floor... and barely was adequate.

I'd say the 4-point or simply a brace between the B-pillar would be a choice setup.

 

[bossesjoe]

Thanks for the advice guys, I totally forgot about Doug Rippie.

At six foot I'm pretty sure I'm going to need some foam padding on the bars.

Autopower also makes a nifty roll bar, anybody have any experience with these?

Anyway, thanks for the replies and help.

-Phil

Edit: I've got another question but I won't make a whole another thread about it.

A long time ago I had a bookmark of a site that sold Dana 44 rear end conversion kits for the C4, but it was on my old computer. Does anyone know the site or company that I'm talking about??

Thanks guys, Phil