Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 8 of 8 Posts

·
Banned
Joined
·
972 Posts
Discussion Starter #1
I installed my Ron Fellows Spoiler today

Gm did NOT Include the template :mad:


So i had to make one !!!!!!!


1. Remove Rear tail ights and Read stock spoiler.
2. Test fit new RF spoiler.
3. Create a template out of paper and instal 8 mm studs to spoiler
4. Trace out template on car and mark and drill 4 3/8 holes
5. Attach taillamp to spoiler apull off sticky tape on bottom.
Fit to car loosely and tighted screws from inside to out( inside left to right).
6. Test brake light before buttoning up.
7. Reinstall 4 taillights.
8. 4 coats of Zanio :rofl:










 

·
Banned
Joined
·
972 Posts
Discussion Starter #3


 

·
Registered
Joined
·
75 Posts
Burton: That is a very nice addition to our C-6. This is one that after seeing your I am thinking about doing on mine. Could U rate how hard this mod is from 1 to 10, 1 being the hardest, and if you don't mind the cost of the part.
 

·
Registered
Joined
·
87 Posts
Look for the "full width racing spoiler" in Genuine Corvette Accessories. It can be purchased through any GM dealer. :cheers:
 

·
Banned
Joined
·
972 Posts
Discussion Starter #8
Sorry for the blurry pics

here are some better ones today

It keeps the Rear end alot cleaner.


I drove over 200 miles today and noticed a major difference on the rear end .

Did not get as dirty as normal

Maybee i am nutz :willy:

 
1 - 8 of 8 Posts
Top