Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
738 Posts
Discussion Starter #1
I am building my exhaust in the next couple weeks. My flane is SS and the mufflers will be SS. Can I weld aluminized steel to these parts with my MIG and argon/C02 mix?
 

·
Banned
Joined
·
1,873 Posts
What a waste of stainless flanges, are they 3" flanges? Want to part with them? Looking for some to use on stainless exhaust. Grind the aluminiized before welding and yes you can weld it w/ mig w/ mild steel wire, no problem.
 

·
Registered
Joined
·
738 Posts
Discussion Starter #3
Thanks TT. These things came with my block huggers, the opening on the flange is 3" but the bottom end is 2 or 2 1/4. I assume they are SS, they been sittin on the bench for months and no rust.
 

·
Banned
Joined
·
1,873 Posts
bottom end? you mean the reducer? Are they stainless block huggers?
 

·
Registered
Joined
·
738 Posts
Discussion Starter #5
They are Ceramic coated block huggers and Yes I mean the reducer
 
1 - 6 of 6 Posts
Top