Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,196 Posts
Why does those pieces need to be welded to the rad? I went a similiar route and just place my mounts in the channel like yours on top of the rad and bolt them down like you can do to the crossmember.
Where are they going to go once bolted. The rad can not move backwards or forwards because of the lip.
I do NOT use the stock mounts for the rad. I made an inverted U for the bottom that the rad just sits over and another inverted U for the top that also bolts to the crossmember.
My rad is not bolt directly anywhere. It free floats between the inverted U's
If the bolting of the top mounts is good nothing will go anywhere.
The welds I see are very nice:thumbsup:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top