Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,523 Posts
Discussion Starter #1
Well I've began assembling my passenger side T/A and when I went to put in the official GM bushing it fell into place without being pressed, so my question is are they suppose to press in. My bushings are already assembled/flared by GM. I need info ASAP.
 

·
Supporting Vendor
Joined
·
3,771 Posts
They can't be flared until they are both in the arm, then compressed to the correct location and then flared to hold them in place.
 

·
Registered
Joined
·
255 Posts
Get the tool for compressing and staking/flaring the bushings. I makes easy work of the installation. If you were nearer to St Louis, you could borrow mine.:thumbsup:
 
1 - 3 of 3 Posts
Top