[tomard]

Can anyone tell me OR have pictures of what pressure switch/housing connector terminals (each one has 2) that the RED/BLACK solenoid wire terminals connect to? Or how I can find out which one goes to where :smack

I was little stupid in my hurry and DIDN'T TAKE A PICTURE when I took it apart!!!!!

 

[SIXFOOTER]

Tom
The red wire on the solenoid (+) goes to the connector pin A
The black (-) will go to D
the black might also go to one side of the pressure switch and the other side of the switch to ground.
It matters because there is a diode across the solenoid coil.
get me a pic pf what you have, I may be able to figger it out from there. Do you have a good shop mnual? If so scan and post the pic on the TCC electrics in the tranny section

 

[tomard]

I will check when I get home if the connector terminals are labeled and I remember when I took the solenoid wire OFF the pressure switch and the housing connector, the solenoid wires were the ONLY terminals in use, so there wasn't any additional wires (to ground or anywhere else)... maybe I am missing some??