Corvette Forum : DigitalCorvettes.com Corvette Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,948 Posts
hey guys
what type of grease should i use for the half shaft u-joints

Thnx
J

I've never really found a better or worse grease.

Do you already have a grease gun? If yes, most parts stores sell refill tubes for it.

If you don't have gun, most parts stores sell gun kits that come with tips, and grease, in a ready to use kit.

Just grab one and go.
 

·
Registered
Joined
·
8 Posts
I do vintage racing so my reply might not apply directly to you. However, the grease that most racers use is Red Line synthetic. I actually clean the original grease out and start fresh with Red Line from the start. I use the same grease for wheel bearings too. The reason for this grease is the ability to supply lubrication under a high heat load. More that likely, any #2 EP synthetic grease will work well too.
 
1 - 3 of 3 Posts
Top