Corvette Forum : DigitalCorvettes.com Corvette Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
50 Posts
It's not that hard or difficult. Take door panel off by prying off with screw driver moldings for outside mirror,around lock,and door handle, then pry up counsel for power locks, windows, and mirror adjustment and disconnect plugs. Remove three screws located behind arm rest handle, inside where counsel was removed, and bottom middle of door panel. Lift panel and pull slighlty towards you. Disconnect courtesy light, and wire to speaker. This may sound like alot but it goes pretty fast. 2. Peel away plastic and loosen window glass clamps (explanation from above, which are accessible when window is in up position). 3. Disconnect wire to motor, and remove 6 bolts holding guide rails and motor. Lift rails slightly to release from little hangers, which come in handy when putting new one in. 4. You should be able to remove entire window regulator at this point. Surprisingly the window stayed in up position when regulator was removed. 5. Before installing new regulator loosen window glass clamps. Install new by first setting guides in place by using the little hangers. Bolt guides and window motor, temporarily connect power window switch and carefully raise window regulator until clamps are resting in place under window glass, tighten clamps. Test before putting panel back on. Hope it helps.
 

· Registered
Joined
·
1,795 Posts
Hard? NO

Pain in the ass? Yes
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top